|
|
PDF TDA3853T Data sheet ( Hoja de datos )
| Número de pieza | TDA3853T | |
| Descripción | TV IF amplifier and demodulator with TV-identification | |
| Fabricantes | NXP Semiconductors | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de TDA3853T (archivo pdf) en la parte inferior de esta página. Total 18 Páginas | ||
|
No Preview Available !
INTEGRATED CIRCUITS
DATA SHEET
TDA3853T
TV IF amplifier and demodulator
with TV-identification
Preliminary specification
File under Integrated Circuits, IC02
January 1992
1 page  
Philips Semiconductors
TV IF amplifier and demodulator with
TV-identification
Sync pulse separator
The sync pulse separator separates
the composite sync signal to gate the
AFT. The vertical sync is used for
identification. The input is
band-limited to obtain a higher ident
sensitivity.
Table 1 Switching functions of TDA3853T.
pin
setting
VIDOFF
PIN 5
L
2.2 µF
TRSW
PIN 7
L(1)
L(1)
VIDEO
SIGNAL
video OFF
video ON
Note
1. capacitor on pin 7 means tracking active; LOW means tracking inactive
Tuner AGC
The tuner AGC output current is fed to
the open-collector output on pin 19.
The take-over point is adjusted
externally at pin 2 to adapt the tuner
and SAW filter to an optimum IF input
level. The IF gain variation over the
full tuner gain range (slip) is
minimized to ensure a constant tuner
output signal.
Identification
An analog integrating network
followed by a window comparator
identifies the video signal by detection
of the duty cycle of the vertical sync
pulses. The pulses charge the
identification capacitor on pin 5.
Tracking generator (AFT)
A limited 90 degree phase-shifted
vision carrier signal is fed to the AFT
quadrature demodulator, internal RC
networks provide active phase
shifting. The linear IF signal is applied
to the other AFT quadrature
demodulator input. The AFT output
signal is applied to a gating stage.
Gating with the composite sync
pulses activates the AFT
demodulator. Therefore the AFT
output is free from video modulation.
The AFT capacitor (pin 7) is charged
by the gated AFT current. The
capacitor voltage is converted to an
DC output current on pin 9
(open-collector sink/source currents).
Preliminary specification
TDA3853T
IDENT
PIN 6
0.5 mA sink
H or 0.5 mA sink
January 1992
5
5 Page 
Philips Semiconductors
TV IF amplifier and demodulator with
TV-identification
Preliminary specification
TDA3853T
Fig.3 Test and application circuit. Test circuit without notch capacitors and with sound trap replaced by a 330 Ω
resistor. Dashed components for tracking application only; application circuit with SWIF.
January 1992
11
11 Page | ||
| Páginas | Total 18 Páginas | |
| PDF Descargar | [ Datasheet TDA3853T.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| TDA3853T | TV IF amplifier and demodulator with TV-identification | NXP Semiconductors |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |