|
|
PDF TDA8050 Data sheet ( Hoja de datos )
| Número de pieza | TDA8050 | |
| Descripción | TDA8046H | |
| Fabricantes | NXP Semiconductors | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de TDA8050 (archivo pdf) en la parte inferior de esta página. Total 24 Páginas | ||
|
No Preview Available !
INTEGRATED CIRCUITS
DATA SHEET
TDA8050
QPSK transmitter
Product specification
Supersedes data of 1999 Jun 21
File under Integrated Circuits, IC02
1999 Dec 14
1 page  
Philips Semiconductors
QPSK transmitter
Product specification
TDA8050
FUNCTIONAL DESCRIPTION
The I and Q are balanced analog signals at a level of
400 mV (p-p). These are mixed by two double balanced
mixers with the output signal generated by a first local
oscillator providing the modulated signal.
The modulated signal is then filtered by an IF filter. This
filtered signal together with a signal generated by a second
local oscillator is converted by a balanced mixer to
produce the QPSK signal.
The QPSK signal is amplified by a gain controlled amplifier
to a level suitable for transmission. The gain of the
controlled amplifier is bus controlled and this amplifier can
be disabled when not transmitting to provide signal
attenuation.
The amplified signal is applied to an on-chip amplifier
having two balanced outputs (open collector) linked to two
chip resistors (values 150 Ω), and 9 V. The balanced
outputs are designed to drive a 2 : 1 transformer
(Siemens V944) with a 75 Ω load giving an output level
of 55 dBmV. The output frequency range of the transmitter
is 5 to 40 MHz.
The frequency of the first local oscillator operates at twice
the frequency (i.e. 280 MHz) fixed by a Phase-Locked
Loop (PLL) implemented in the circuit.
The frequency of the second local oscillator operates in the
bandwidth 145 to 180 MHz and programmable due to a
PLL implemented in the circuit.
The VCO of both first and second local oscillators requires
an external LC tank circuit with two varicap diodes.
The data to the PLL is loaded in bursts framed by the
signal EN. Programming rising clock edges and their
appropriate data bits are ignored until EN goes active
(LOW). The internal latches are updated with the latest
programming data when EN returns inactive (HIGH).
The last 14 bits are stored in the programming register.
No check is made on the number of clock pulses received
during the time programming is enabled. A wrong active
clock edge will be generated causing a shift of data
bits, if EN goes HIGH while CLK is still LOW. At power
up, EN should be HIGH. The lock detector output LOCK is
HIGH when both PLLs are in lock.
The main divider ratio and the reference divider ratios are
provided via the serial bus. A control register controls the
Digital-to-Analog Converter (DAC), the output amplifier
and the charge pump currents (Tables 1, 2 and 3).
LIMITING VALUES
In accordance with the Absolute Maximum Rating System (IEC 134).
SYMBOL
VCC
tsc
Vmax
Vo(tune)
Vo(buf)
Ptot
Tamb
Tstg
Tj(max)
PARAMETER
supply voltage
short-circuit time (every pin to VCC or GND)
voltage on all pins except BUF_OUT, BUF_OUTC and TUNECONV
output tuning voltage
output buffer voltage on pins BUF_OUT and BUF_OUTC
maximum power dissipation
operating ambient temperature
storage temperature
junction temperature
MIN.
−0.3
−
−0.3
−0.3
−
−
0
−40
−
MAX.
+6.0
10
VCC
+30
10
800
70
+150
150
UNIT
V
s
V
V
V
mW
°C
°C
°C
1999 Dec 14
5
5 Page 
Philips Semiconductors
QPSK transmitter
Product specification
TDA8050
handbook, full pagewidth
50 Ω
RF_IN BUF_OUT
RF_INC
BUF_OUTC
150 Ω
150 Ω
Siemens V944
Vo2
9 V 75 Ω
gain
(dB)
Gmax
Gmax − 1
Vo(−1 dB)
Vo
FCE185
DAC = 31.
f = 26.5 MHz.
Vi is variable to have a variable output voltage.
Fig.5 Maximum gain and compression point.
handbook, full pagewidth
RF_IN BUF_OUT
RF_INC
BUF_OUTC
Siemens V944
150 Ω
150 Ω
9V
75 Ω
FCE186
DAC = 28.
fi = 5 to 40 MHz.
Vi = 200 mV sine wave.
Vo = 55 dBmV (RMS value).
1999 Dec 14
Fig.6 Harmonics of output section H2 and H3.
11
11 Page | ||
| Páginas | Total 24 Páginas | |
| PDF Descargar | [ Datasheet TDA8050.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| TDA8050 | TDA8046H | NXP Semiconductors |
| TDA8050A | QPSK transmitter | NXP Semiconductors |
| TDA8051 | QPSK receiver | NXP Semiconductors |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |