|
|
Número de pieza | TDA8011T | |
Descripción | IF amplifier for satellite TV receivers | |
Fabricantes | NXP Semiconductors | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de TDA8011T (archivo pdf) en la parte inferior de esta página. Total 12 Páginas | ||
No Preview Available ! INTEGRATED CIRCUITS
DATA SHEET
TDA8011T
IF amplifier for satellite TV receivers
Product specification
File under Integrated Circuits, IC02
February 1995
Philips Semiconductors
1 page Philips Semiconductors
IF amplifier for satellite TV receivers
Product specification
TDA8011T
SYMBOL
PARAMETER
CONDITIONS
MIN.
TYP.
MAX. UNIT
Gain control
VAGC
RAGC1
RAGC2
AGC input voltage
AGC resistor 1
AGC resistor 2
G ≤ Gv(min)
G ≥ Gv(max)
0.1VCC
−
−
−
−
−
4.3
110
−
0.9VCC
−
−
V
V
kΩ
kΩ
Notes
1. The voltage gain Gv is defined as the ratio between the single-ended output voltage and the differential input voltage
with
a 150 Ω
output load:
G
=
20
×
log
V----V-I-F--i-O--
2. The tilt is defined as the maximum absolute difference between the gain at the frequency fo = 480 MHz and the gain
at the frequency fo = 480 MHz ±20 MHz. Where ∆Gv = maxG(fo ±∆f) − G(fo)
3. The unmatched noise figure (F) is measured at fi = 480 MHz in the application circuit (see Fig.6). With the hybrid
coupler used, the equivalent source impedance is equal to 100 Ω.
4. The minimum noise figure [F(min)] is measured at fi = 480 MHz with the input matching circuit shown in Fig.3;
(L1: 4.5 turns on, Φint = 3 mm, wire = 0.4 mm; L2: 11 turns on, Φint = 3 mm, wire = 0.4 mm).
5. The third-order intermodulation distance (IM3) is measured with an AGC voltage set to obtain a gain of −17 dB. The
input signal applied to the amplifier consists of two sine wave signals at fi = 479.5 MHz and fi = 480.5 MHz with an
amplitude equal to 90 dBµV for each tone.
6. The differential input impedance is represented by an equivalent parallel resistance and capacitance as shown in
Fig.1. The specified values are measured at fi = 480 MHz.
February 1995
Fig.3 Input matching circuit.
5
5 Page Philips Semiconductors
IF amplifier for satellite TV receivers
NOTES
Product specification
TDA8011T
February 1995
11
11 Page |
Páginas | Total 12 Páginas | |
PDF Descargar | [ Datasheet TDA8011T.PDF ] |
Número de pieza | Descripción | Fabricantes |
TDA8011T | IF amplifier for satellite TV receivers | NXP Semiconductors |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |