DataSheetWiki


UT8CR512K32-17VCC fiches techniques PDF

Aeroflex Circuit Technology - UT8CR512K32 16 Megabit SRAM

Numéro de référence UT8CR512K32-17VCC
Description UT8CR512K32 16 Megabit SRAM
Fabricant Aeroflex Circuit Technology 
Logo Aeroflex Circuit Technology 





1 Page

No Preview Available !





UT8CR512K32-17VCC fiche technique
Standard Products
UT8CR512K32 16 Megabit SRAM
Advanced Data Sheet
October 2004
www.aeroflex.com/4MSRAM
FEATURES
‰ 17ns maximum access time
‰ Asynchronous operation for compatibility with industry-
standard 512K x 8 SRAMs
‰ CMOS compatible inputs and output levels, three-state
bidirectional data bus
- I/O Voltage 3.3 volts, 1.8 volt core
‰ Radiation performance
- Intrinsic total-dose: 300 Krad(Si)
- SEL Immune >100 MeV-cm2/mg
- LETth (0.25): 53.0 MeV-cm2/mg
- Memory Cell Saturated Cross Section 1.67E-7cm2/bit
- Neutron Fluence: 3.0E14n/cm2
- Dose Rate
- Upset 1.0E9 rad(Si)/sec
- Latchup 1.0E11 rad(Si)/sec
‰ Packaging options:
- 68-lead ceramic quad flatpack (20.238 grams with lead
frame)
‰ Standard Microcircuit Drawing 5962-04227
- QML compliant part
INTRODUCTION
The UT8CR512K32 is a high-performance CMOS static RAM
multi-chip module (MCM), organized as four individual
524,288 words by 8 bit SRAMs with common output enable.
Easy memory expansion is provided by active LOW chip
enables (EN), an active LOW output enable (G), and three-state
drivers. This device has a power-down feature that reduces
power consumption by more than 90% when deselected.
Writing to each memory is accomplished by taking the
corresponding chip enable (En) input LOW and write enable
(Wn) input LOW. Data on the I/O pins is then written into the
location specified on the address pins (A0 through A18). Reading
from the device is accomplished by taking the chip enable (En)
and output enable (G) LOW while forcing write enable (Wn)
HIGH. Under these conditions, the contents of the memory
location specified by the address pins will appear on the I/O pins.
The input/output pins are placed in a high impedance state when
the device is deselected (En HIGH), the outputs are disabled (G
HIGH), or during a write operation (En LOW and Wn LOW).
Perform 8, 16, 24 or 32 bit accesses by making Wn along with
En a common input to any combination of the discrete memory
die.
W3
E3
W2
E2
W1
E1
W0
E0
A(18:0)
G
512K x 8
512K x 8
512K x 8
512K x 8
DQ(31:24)
or
DQ3(7:0)
DQ(23:16)
or
DQ2(7:0)
DQ(15:8)
or
DQ1(7:0)
Figure 1. UT8CR512K32 SRAM Block Diagram
DQ(7:0)
or
DQ0(7:0)
1

PagesPages 16
Télécharger [ UT8CR512K32-17VCC ]


Fiche technique recommandé

No Description détaillée Fabricant
UT8CR512K32-17VCA UT8CR512K32 16 Megabit SRAM Aeroflex Circuit Technology
Aeroflex Circuit Technology
UT8CR512K32-17VCC UT8CR512K32 16 Megabit SRAM Aeroflex Circuit Technology
Aeroflex Circuit Technology
UT8CR512K32-17VCX UT8CR512K32 16 Megabit SRAM Aeroflex Circuit Technology
Aeroflex Circuit Technology

US18650VTC5A

Lithium-Ion Battery

Sony
Sony
TSPC106

PCI Bus Bridge Memory Controller

ATMEL
ATMEL
TP9380

NPN SILICON RF POWER TRANSISTOR

Advanced Semiconductor
Advanced Semiconductor


www.DataSheetWiki.com    |   2020   |   Contactez-nous  |   Recherche