DataSheetWiki


X24128S-1.8 fiches techniques PDF

Xicor - 400KHz 2-Wire Serial E2PROM with Block Lock

Numéro de référence X24128S-1.8
Description 400KHz 2-Wire Serial E2PROM with Block Lock
Fabricant Xicor 
Logo Xicor 





1 Page

No Preview Available !





X24128S-1.8 fiche technique
128K
X24128
400KHz 2-Wire Serial E2PROM with Block LockTM
16K x 8 Bit
FEATURES
Save Critical Data with Programmable
Block Lock Protection
—Block Lock (0, 1/4, 1/2, or all of E2PROM Array)
—Software Write Protection
—Programmable Hardware Write Protect
In Circuit Programmable ROM Mode
400KHz 2-Wire Serial Interface
—Schmitt Trigger Input Noise Suppression
—Output Slope Control for Ground Bounce
Noise Elimination
Longer Battery Life With Lower Power
—Active Read Current Less Than 1mA
—Active Write Current Less Than 3mA
—Standby Current Less Than 1µA
1.8V to 3.6V, 2.5V to 5.5V and 4.5V to 5.5V
Power Supply Versions
32 Word Page Write Mode
—Minimizes Total Write Time Per Word
Internally Organized 16K x 8
Bidirectional Data Transfer Protocol
Self-Timed Write Cycle
—Typical Write Cycle Time of 5ms
High Reliability
—Endurance: 100,000 Cycles
—Data Retention: 100 Years
14-Lead SOIC
16-Lead SOIC
8-Lead PDIP
FUNCTIONAL DIAGRAM
DESCRIPTION
The X24128 is a CMOS Serial E2PROM, internally
organized 16K x 8. The device features a serial inter-
face and software protocol allowing operation on a
simple two wire bus.
Three device select inputs (S0–S2) allow up to eight
devices to share a common two wire bus.
A Write Protect Register at the highest address loca-
tion, FFFFh, provides three write protection features:
Software Write Protect, Block Lock Protect, and
Programmable Hardware Write Protect. The Software
Write Protect feature prevents any nonvolatile writes to
the device until the WEL bit in the Write Protect
Register is set. The Block Lock Protection feature
gives the user four array block protect options, set by
programming two bits in the Write Protect Register.
The Programmable Hardware Write Protect feature
allows the user to install the device with WP tied to
VCC, write to and Block Lock the desired portions of
the memory array in circuit, and then enable the In
Circuit Programmable ROM Mode by programming the
WPEN bit HIGH in the Write Protect Register. After
this, the Block Locked portions of the array, including
the Write Protect Register itself, are permanently
protected from being erased.
SERIAL E2PROM DATA
AND ADDRESS (SDA)
DATA REGISTER
Y DECODE LOGIC
SCL
S2
S1
S0
COMMAND
DECODE
AND
CONTROL
LOGIC
BLOCK LOCK AND
WRITE PROTECT
CONTROL LOGIC
PAGE
DECODE
LOGIC
DEVICE
SELECT
LOGIC
WRITE
PROTECT
REGISTER
SERIAL E2PROM
ARRAY
16K x 8
4K x 8
4K x 8
8K x 8
WP
©Xicor, 1995, 1996 Patents Pending
7027-1.3 5/14/97 T2/C0/D2 SH
WRITE VOLTAGE
CONTROL
7027 FM 01
Characteristics subject to change without notice
1

PagesPages 17
Télécharger [ X24128S-1.8 ]


Fiche technique recommandé

No Description détaillée Fabricant
X24128S-1.8 400KHz 2-Wire Serial E2PROM with Block Lock Xicor
Xicor

US18650VTC5A

Lithium-Ion Battery

Sony
Sony
TSPC106

PCI Bus Bridge Memory Controller

ATMEL
ATMEL
TP9380

NPN SILICON RF POWER TRANSISTOR

Advanced Semiconductor
Advanced Semiconductor


www.DataSheetWiki.com    |   2020   |   Contactez-nous  |   Recherche