DataSheetWiki


DS28E04S-100 fiches techniques PDF

Dallas Semiconducotr - 4096-Bit Addressable 1-Wire EEPROM with PIO

Numéro de référence DS28E04S-100
Description 4096-Bit Addressable 1-Wire EEPROM with PIO
Fabricant Dallas Semiconducotr 
Logo Dallas Semiconducotr 





1 Page

No Preview Available !





DS28E04S-100 fiche technique
www.maxim-ic.com
GENERAL DESCRIPTION
The DS28E04-100 is a 4096-bit, 1-Wire® EEPROM
chip with seven address inputs. The address inputs
are directly mapped into the 1-Wire 64-bit Device ID
Number to easily enable the host system to identify
the physical location or functional association of the
DS28E04-100 in a multidevice 1-Wire network en-
vironment. The 4096-bit EEPROM array is configured
as 16 pages of 32 bytes with a 32 byte scratchpad to
perform write operations. EEPROM memory pages
can be individually write protected or put in EPROM-
emulation mode, where bits can only be changed
from a 1 to a 0 state. In addition to the memory, the
DS28E04-100 has two general-purpose I/O ports that
can be used for input or to generate level and/or
pulse outputs. Activity registers also capture port
activity for state change monitoring. The DS28E04-
100 communicates over the single-contact 1-Wire
bus. The communication follows the standard Dallas
Semiconductor 1-Wire protocol.
APPLICATIONS
· Autoconfiguration of Modular Systems such as
Central-Office Switches, Cellular Base Stations,
Access Products, Optical Network Units, and
PBXs
· Accessory/PCB Identification
TYPICAL OPERATING CIRCUIT
VCC
RPUP
PX.Y
µC
LED
IO VCC A6
POL
P1
P0
GND
A0
DS28E04 #1
IO VCC A6
POL
P1
P0
GND
A0
RST1 RST0 DS28E04 #7
DS28E04-100
4096-Bit Addressable 1-Wire EEPROM
with PIO
FEATURES
· 4096 bits of EEPROM Memory Partitioned into
16 Pages of 256 Bits
· Seven Address Inputs for Physical Location
Configuration
· Two General-Purpose PIO Pins with Pulse-
Generation Capability
§ Individual Memory Pages can be Permanently
Write-Protected or put in OTP EPROM-
Emulation Mode (“Write to 0”)
§ Communicates to Host with a Single Digital
Signal at 15.3kbps or 111kbps Using 1-Wire
Protocol
§ Parasitic or VCC Powered
§ Conditional Search Based on PIO Status or PIO
Activity
§ Switchpoint Hysteresis and Filtering to Optimize
Performance in the Presence of Noise
§ Reads and Writes Over a Wide 2.8V to 5.25V
Voltage Range from -40°C to +85°C
§ 16-Pin, 150-mil SO Package
ORDERING INFORMATION
PART
TEMP RANGE PIN-PACKAGE
DS28E04S-100
-40°C to +85°C 16 SO (150 mils)
DS28E04S-100/T&R -40°C to +85°C Tape-and-Reel
PIN CONFIGURATION
A3
A2
A1
A0
GND
N.C.
VCC
POL
1 16 IO
2 15 A4
3 14 A5
4 13 A6
5 12 GND
6 11 N.C.
7 10 P1
8 9 P0
SO (150 mils)
Commands, Registers, and Modes are capitalized for
clarity.
1-Wire is a registered trademark of Dallas Semiconductor Corp.
Note: Some revisions of this device may incorporate deviations from published specifications known as errata. Multiple revisions of any device
may be simultaneously available through various sales channels. For information about device errata, click here: www.maxim-ic.com/errata.
1 of 36
REV: 102704

PagesPages 30
Télécharger [ DS28E04S-100 ]


Fiche technique recommandé

No Description détaillée Fabricant
DS28E04S-100 4096-Bit Addressable 1-Wire EEPROM with PIO Dallas Semiconducotr
Dallas Semiconducotr
DS28E04S-100 4096-Bit Addressable 1-Wire EEPROM with PIO Dallas Semiconducotr
Dallas Semiconducotr

US18650VTC5A

Lithium-Ion Battery

Sony
Sony
TSPC106

PCI Bus Bridge Memory Controller

ATMEL
ATMEL
TP9380

NPN SILICON RF POWER TRANSISTOR

Advanced Semiconductor
Advanced Semiconductor


www.DataSheetWiki.com    |   2020   |   Contactez-nous  |   Recherche