|
|
Número de pieza | 74ABT16541 | |
Descripción | 16-Bit Buffer/Line Driver with 3-STATE Outputs | |
Fabricantes | Fairchild Semiconductor | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de 74ABT16541 (archivo pdf) en la parte inferior de esta página. Total 8 Páginas | ||
No Preview Available ! July 1996
Revised November 1999
74ABT16541
16-Bit Buffer/Line Driver with 3-STATE Outputs
General Description
The ABT16541 contains sixteen non-inverting buffers with
3-STATE outputs designed to be employed as a memory
and address driver, clock driver, or bus oriented transmit-
ter/receiver. The device is byte controlled. Individual 3-
STATE control inputs can be shorted together for 8-bit or
16-bit operation.
Features
s Separate control logic for each nibble
s 16-bit version of the ABT541
s Outputs sink capability of 64 mA, source capability of
32 mA
s Guaranteed simultaneous switching noise level and
dynamic threshold performance
s Guaranteed latchup protection
s High impedance glitch free bus loading during entire
power up and power down cycle
s Non-destructive hot insertion capability
Ordering Code:
Order Number Package Number
Package Description
74ABT16541CSSC
MS48A
48-Lead Small Shrink Outline Package (SSOP), JEDEC MO-118, 0.300” Wide
74ABT16541CMTD
MTD48
48-Lead Thin Shrink Small Outline Package (TSSOP), JEDEC MO-153, 6.1mm Wide
Device also available in Tape and Reel. Specify by appending the suffix letter “X” to the ordering code.
Logic Symbol
Connection Diagram
Pin Descriptions
Pin Names
OE n
I0–I15
O0–O15
Description
Output Enable Inputs (Active Low)
Inputs
Outputs
© 1999 Fairchild Semiconductor Corporation DS012149
www.fairchildsemi.com
1 page Skew
TA = −40°C to +85°C
TA = −40°C to +85°C
VCC = 4.5V–5.5V
VCC = 4.5V–5.5V
Symbol
Parameter
CL = 50 pF
16 Outputs Switching
CL = 250 pF
16 Outputs Switching
Units
(Note 11)
(Note 12)
Max
Max
tOSHL
(Note 13)
Pin to Pin Skew
HL Transitions
1.0 1.5 ns
tOSLH
(Note 13)
Pin to Pin Skew
LH Transitions
1.0 1.5 ns
tPS
(Note 14)
Duty Cycle
LH–HL Skew
1.5 1.5 ns
tOST
(Note 13)
Pin to Pin Skew
LH/HL Transitions
1.7 2.0 ns
tPV
(Note 15)
Device to Device Skew
LH/HL Transitions
2.0 2.5 ns
Note 11: This specification is guaranteed but not tested. The limits apply to propagation delays for all paths described switching in phase
(i.e., all LOW-to-HIGH, HIGH-to-LOW, etc.)
Note 12: These specifications guaranteed but not tested. The limits represent propagation delays with 250 pF load capacitors in place of the 50 pF load
capacitors in the standard AC load.
Note 13: Skew is defined as the absolute value of the difference between the actual propagation delays for any two separate outputs of the same device.
The specification applies to any outputs switching HIGH-to-LOW (tOSHL), LOW-to-HIGH (tOSLH), or any combination switching LOW-to-HIGH and/or HIGH-
to-LOW (tOST). The specification is guaranteed but not tested.
Note 14: This describes the difference between the delay of the LOW-to-HIGH and the HIGH-to-LOW transition on the same pin. It is measured across all
the outputs (drivers) on the same chip, the worst (largest delta) number is the guaranteed specification. This specification is guaranteed but not tested.
Note 15: Propagation delay variation for a given set of conditions (i.e., temperature and VCC) from device to device. This specification is guaranteed but not
tested.
Capacitance
Symbol
Parameter
Typ
CIN
COUT (Note 16)
Input Capacitance
Output Capacitance
5.0
9.0
Note 16: COUT is measured at frequency f = 1 MHz; per MIL STD-883, Method 3012.
Units
pF
pF
Conditions
TA = 25°C
VCC = 5.0V
VCC = 5.0V
5 www.fairchildsemi.com
5 Page |
Páginas | Total 8 Páginas | |
PDF Descargar | [ Datasheet 74ABT16541.PDF ] |
Número de pieza | Descripción | Fabricantes |
74ABT16541 | 16-bit buffer/line driver 3-State | NXP Semiconductors |
74ABT16541 | 16-Bit Buffer/Line Driver with 3-STATE Outputs | Fairchild Semiconductor |
74ABT16543 | 16-bit latched transceivers with dual enable 3-State | NXP Semiconductors |
74ABT16543 | 16-Bit Registered Transceiver with 3-STATE Outputs | Fairchild Semiconductor |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |