DataSheetWiki


5962-9864601QEA fiches techniques PDF

Analog Devices - 5 MHz-400 MHz 100 dB High Precision Limiting-Logarithmic Amplifier

Numéro de référence 5962-9864601QEA
Description 5 MHz-400 MHz 100 dB High Precision Limiting-Logarithmic Amplifier
Fabricant Analog Devices 
Logo Analog Devices 





1 Page

No Preview Available !





5962-9864601QEA fiche technique
a
5 MHz–400 MHz 100 dB High Precision
Limiting-Logarithmic Amplifier
AD8306
FEATURES
Complete, Fully Calibrated Log-Limiting IF Amplifier
100 dB Dynamic Range: –91 dBV to +9 dBV
Stable RSSI Scaling Over Temperature and Supplies:
20 mV/dB Slope, –95 dBm Intercept
؎0.4 dB RSSI Linearity up to 200 MHz
Programmable Limiter Gain and Output Current
Differential Outputs to 10 mA, 2.4 V p-p
Overall Gain 90 dB, Bandwidth 400 MHz
Constant Phase (Typical ؎56 ps Delay Skew)
Single Supply of +2.7 V to +6.5 V at 16 mA Typical
Fully Differential Inputs, RIN = 1 k, CIN = 2.5 pF
500 ns Power-Up Time, <1 A Sleep Current
APPLICATIONS
Receivers for Frequency and Phase Modulation
Very Wide Range IF and RF Power Measurement
Receiver Signal Strength Indication (RSSI)
Low Cost Radar and Sonar Signal Processing
Instrumentation: Network and Spectrum Analyzers
FUNCTIONAL BLOCK DIAGRAM
SIX STAGES TOTAL GAIN 72dB
TYP GAIN 18dB
INHI
INLO
12dB
LADR ATTEN
4 ؋ DET
DET
12dB
DET
12dB
LIM
DET
BIAS
CTRL
LMHI
LMLO
LMDR
TEN DETECTORS SPACED 12dB
I–V VLOG
FLTR
ENBL
GAIN
BIAS
BAND-GAP
REFERENCE
SLOPE
BIAS
INTERCEPT
TEMP COMP
PRODUCT DESCRIPTION
The AD8306 is a complete IF limiting amplifier, providing both
an accurate logarithmic (decibel) measure of the input signal
(the RSSI function) over a dynamic range of 100 dB, and a
programmable limiter output, useful from 5 MHz to 400 MHz.
It is easy to use, requiring few external components. A single
supply voltage of +2.7 V to +6.5 V at 16 mA is needed, corre-
sponding to a power consumption of under 50 mW at 3 V, plus
the limiter bias current, determined by the application and typi-
cally 2 mA, providing a limiter gain of 90 dB when using 200
loads. A CMOS-compatible control interface can enable the
AD8306 within about 500 ns and disable it to a standby current
of under 1 µA.
The six cascaded amplifier/limiter cells in the main path have a
small signal gain of 12.04 dB (×4), with a –3 dB bandwidth of
850 MHz, providing a total gain of 72 dB. The programmable
output stage provides a further 18 dB of gain. The input is fully
differential and presents a moderately high impedance (1 kin
parallel with 2.5 pF). The input-referred noise-spectral-density,
when driven from a terminated 50 , source is 1.28 nV/Hz,
equivalent to a noise figure of 3 dB. The sensitivity of the
AD8306 can be raised by using an input matching network.
Each of the main gain cells includes a full-wave detector. An
additional four detectors, driven by a broadband attenuator, are
used to extend the top end of the dynamic range by over 48 dB.
The overall dynamic range for this combination extends from
–91 dBV (–78 dBm at the 50 level) to a maximum permissible
value of +9 dBV, using a balanced drive of antiphase inputs each of
2 V in amplitude, which would correspond to a sine wave power
of +22 dBm if the differential input were terminated in 50 .
Through laser trimming, the slope of the RSSI output is closely
controlled to 20 mV/dB, while the intercept is set to –108 dBV
(–95 dBm re 50 ). These scaling parameters are determined
by a band-gap voltage reference and are substantially indepen-
dent of temperature and supply. The logarithmic law conform-
ance is typically within ± 0.4 dB over the central 80 dB of this
range at any frequency between 10 MHz and 200 MHz, and is
degraded only slightly at 400 MHz.
The RSSI response time is nominally 73 ns (10%–90%). The
averaging time may be increased without limit by the addition of
an external capacitor. The full output of 2.34 V at the maximum
input of +9 dBV can drive any resistive load down to 50 and
this interface remains stable with any value of capacitance on
the output.
The AD8306 is fabricated on an advanced complementary
bipolar process using silicon-on-insulator isolation techniques
and is available in the industrial temperature range of –40°C to
+85°C, in a 16-lead narrow body SO package. The AD8306 is
also available for the full military temperature range of –55°C to
+125°C, in a 16-lead side-brazed ceramic DIP.
REV. A
Information furnished by Analog Devices is believed to be accurate and
reliable. However, no responsibility is assumed by Analog Devices for its
use, nor for any infringements of patents or other rights of third parties
which may result from its use. No license is granted by implication or
otherwise under any patent or patent rights of Analog Devices.
One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.
Tel: 781/329-4700 World Wide Web Site: http://www.analog.com
Fax: 781/326-8703
© Analog Devices, Inc., 1999

PagesPages 16
Télécharger [ 5962-9864601QEA ]


Fiche technique recommandé

No Description détaillée Fabricant
5962-9864601QEA 5 MHz-400 MHz 100 dB High Precision Limiting-Logarithmic Amplifier Analog Devices
Analog Devices

US18650VTC5A

Lithium-Ion Battery

Sony
Sony
TSPC106

PCI Bus Bridge Memory Controller

ATMEL
ATMEL
TP9380

NPN SILICON RF POWER TRANSISTOR

Advanced Semiconductor
Advanced Semiconductor


www.DataSheetWiki.com    |   2020   |   Contactez-nous  |   Recherche