DataSheetWiki


DS481M fiches techniques PDF

National Semiconductor - Low Power RS-485/RS-422 Multipoint Transceiver with Sleep Mode

Numéro de référence DS481M
Description Low Power RS-485/RS-422 Multipoint Transceiver with Sleep Mode
Fabricant National Semiconductor 
Logo National Semiconductor 





1 Page

No Preview Available !





DS481M fiche technique
July 1998
DS481
Low Power RS-485/RS-422 Multipoint Transceiver with
Sleep Mode
General Description
The DS481 is a low-power transceiver for RS-485 and
RS-422 communication. The device contains one driver and
one receiver. The drivers slew rate allows for operation up to
2.0 Mbps (see Applications Information section).
The transceiver draws 200 µA of supply current when un-
loaded or 0.2 µA when in the automatic sleep mode. Sleep
mode is activated by inactivity on the enables (DE and RE
(Note 1)). Holding DE =L and RE (Note 1)=H for greater than
600 ns will enable the sleep mode. The DS481 operates
from a single +5V supply.
The driver is short-circuit current limited and is protected
against excessive power dissipation by thermal shutdown
circuitry that places the driver outputs into TRI-STATE®
(High Impedance state) under fault conditions. The driver
guarantees a minimum of 1.5V differential output voltage
with maximum loading across the common mode range
(VOD3).
The receiver has a failsafe feature that guarantees a
logic-high output if the input is open circuit.
The DS481 is available in surface mount and DIP packages
and is characterized for Industrial and Commercial tempera-
ture range operation.
Features
n Meets TIA/EIA RS-485 multipoint standard
n Sleep mode reduces ICC to 0.2 µA
n Guaranteed full load output voltage (V OD3)
n Low quiescent current: 200 µA typ
n −7V to +12V common-mode input voltage range
n TRI-STATE outputs on driver and receiver
n AC performance:
— Driver transition time: 25 ns typ
— Driver propagation delay: 40 ns typ
— Driver skew: 1 ns typ
— Receiver propagation delay: 200 ns typ
— Receiver skew: 20 ns typ
n Half-duplex flow through pinout
n Operates from a single 5V supply
n Allows up to 128 transceivers on the bus (DS481N/M)
n Allows up to 64 tranceivers on the bus (DS481TN/M)
n Current-limiting and thermal shutdown for driver
overload protection
n Industrial temperature range operation
n Pin and functional compatible with MAX481C and
MAX481E
Connection and Logic Diagram
*Note: Non Terminated, Open Input only
DS012919-1
Order Number
DS481N
DS481M
DS481TN
DS481TM
Temp. Range
0˚C to +70˚C
0˚C to +70˚C
−40˚C to +85˚C
−40˚C to +85˚C
Package/###
DIP/N08E
SOP/M08A
DIP/N08E
SOP/M08A
Truth Table
DRIVER SECTION
RE DE DI A
(Note 1)
B
X H HH
L
X H LL
H
X L X Z Z (Note 2)
RECEIVER SECTION
RE
(Note 1)
DE
A-B
RO
LL
LL
+0.2V
−0.2V
H
L
HX
X Z (Note 2)
L
L OPEN (Note 1)
H
X = indeterminate
Z = TRI-STATE
Note 1: Non Terminated, Open Input only
Note 2: Device enters sleep mode if enable conditions are held > 600 ns,
DE = L and RE (Note 1) = H.
TRI-STATE® is a registered trademark of National Semiconductor Corporation.
© 1999 National Semiconductor Corporation DS012919
www.national.com

PagesPages 10
Télécharger [ DS481M ]


Fiche technique recommandé

No Description détaillée Fabricant
DS481 Low Power RS-485/RS-422 Multipoint Transceiver with Sleep Mode National Semiconductor
National Semiconductor
DS481 DS481 Low Power RS-485/RS-422 Multipoint Transceiver with Sleep Mode (Rev. B) Texas Instruments
Texas Instruments
DS481M Low Power RS-485/RS-422 Multipoint Transceiver with Sleep Mode National Semiconductor
National Semiconductor
DS481N Low Power RS-485/RS-422 Multipoint Transceiver with Sleep Mode National Semiconductor
National Semiconductor

US18650VTC5A

Lithium-Ion Battery

Sony
Sony
TSPC106

PCI Bus Bridge Memory Controller

ATMEL
ATMEL
TP9380

NPN SILICON RF POWER TRANSISTOR

Advanced Semiconductor
Advanced Semiconductor


www.DataSheetWiki.com    |   2020   |   Contactez-nous  |   Recherche