|
|
PDF HMC400MS8 Data sheet ( Hoja de datos )
| Número de pieza | HMC400MS8 | |
| Descripción | HIGH IP3 GaAs MMIC MIXER/ 1.7 - 2.2 GHz | |
| Fabricantes | Hittite Microwave Corporation | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de HMC400MS8 (archivo pdf) en la parte inferior de esta página. Total 6 Páginas | ||
|
No Preview Available !
v01.1003
MICROWAVE CORPORATION
HMC400MS8
HIGH IP3 GaAs MMIC
MIXER, 1.7 - 2.2 GHz
12
Typical Applications
High Dynamic Range Infrastructure:
• GSM, GPRS & EDGE
• CDMA & W-CDMA
• Cable Modem Termination Systems
Functional Diagram
Features
+35 dBm Input IP3
Conversion Loss: 8.8 dB
No External Components
Ultra Small MSOP Package: 14.8mm2
General Description
The HMC400MS8 is a high dynamic range passive
MMIC mixer in a plastic surface mount 8 lead Mini
Small Outline Package (MSOP) covering 1.7 to 2.2
GHz. Excellent input IP3 performance of +36 dBm
for down conversion and +29 dBm for up conversion
is provided for 2.5G & 3G GSM/CDMA based UMTS
or PCS applications at an LO drive of +17dBm.
With a 1dB compression of +21 dBm, the RF port
will accept a wide range of input signal levels.
Conversion loss is 8.5dB typical and LO isolations
are maintained at 22 to 33 dB. This miniature single-
ended monolithic GaAs FET mixer does not require
any external components or bias.The 50 to 300 MHz
IF frequency response will satisfy many UMTS/PCS
transmit or receive frequency plans configured for low
side LO. The HMC400MS8 input IP3 performance
coupled with its high P1dB rivals traditional
active FET mixers while offering a much smaller
14.8mm2 standard IC footprint and no DC bias.
Electrical Specifications, TA = +25°C, LO = +17dBm, IF = 200 MHz*
Parameter
Min. Typ. Max. Min. Typ. Max. Min.
Typ. Max. Units
Frequency Range, RF
1.7 - 1.8
1.8 - 2.0
2.0 - 2.2
GHz
Frequency Range, LO
1.4 - 1.75
1.5 - 1.95
1.7 - 2.15
GHz
Frequency Range, IF
DC - 300
DC - 300
DC - 300
MHz
Conversion Loss
9 11
8.8 10.5
8.8 10.5
dB
Noise Figure (SSB)
9 11
8.8 10.5
8.8 10.5
dB
LO to RF Isolation
29 33
24 30
20 25
dB
LO to IF Isolation
16 20
17 22
19 25
dB
IP3 (Input)
30 34
32 36
28 32
dBm
1 dB Gain Compression (Input)
18 21
18 21
18 22
dBm
LO Input Drive Level (Typical)
+16 to +18
+16 to +18
+16 to +18
dBm
*Unless otherwise noted, all measurements performed as a downconverter, with low side LO & IF = 200 MHz.
12 - 212
For price, delivery, and to place orders, please contact Hittite Microwave Corporation:
12 Elizabeth Drive, Chelmsford, MA 01824 Phone: 978-250-3343 Fax: 978-250-3373
Order Online at www.hittite.com
1 page  
v01.1003
MICROWAVE CORPORATION
Outline Drawing
HMC400MS8
HIGH IP3 GaAs MMIC
MIXER, 1.7 - 2.2 GHz
12
Pin Descriptions
Pin Number
Function
1 LO
NOTES:
1. PACKAGE BODY MATERIAL: LOW STRESS INJECTION MOLDED
PLASTIC SILICA AND SILICON IMPREGNATED.
2. LEAD MATERIAL: COPPER ALLOY
3 LEAD PLATING: Sn/Pb SOLDER
4. DIMENSIONS ARE IN INCHES [MILLIMETERS]
5. DIMENSION DOES NOT INCLUDE MOLDFLASH OF 0.15mm PER SIDE.
6. DIMENSION DOES NOT INCLUDE MOLDFLASH OF 0.25mm PER SIDE.
7. ALL GROUND LEADS AND GROUND PADDLE MUST BE SOLDERED
TO THE PCB RF GROUND
Description
This pin is AC coupled & matched to 50 Ohms
from 1.4 to 2.2 GHz. Blocking capacitors are required if line
potential is not equal to 0V.
Interface Schematic
2, 4
3, 6, 7
5
N/C
GND
IF Port
Not connected.
This pin must be connected to RF ground.
This pin is DC coupled. For applications not requiring
operation to DC this port should be DC blocked externally
using a series capacitor. Choose value of capacitor to pass
IF frequency desired. For operation to DC, this pin must not
sink/source more than 40 mA of current or failure may result.
8 RF Port
This pin is DC coupled & matched to 50 Ohm
from 1.7 to 2.2 GHz
12 - 216
For price, delivery, and to place orders, please contact Hittite Microwave Corporation:
12 Elizabeth Drive, Chelmsford, MA 01824 Phone: 978-250-3343 Fax: 978-250-3373
Order Online at www.hittite.com
5 Page | ||
| Páginas | Total 6 Páginas | |
| PDF Descargar | [ Datasheet HMC400MS8.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| HMC400MS8 | HIGH IP3 GaAs MMIC MIXER/ 1.7 - 2.2 GHz | Hittite Microwave Corporation |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |