|
|
PDF ADG706 Data sheet ( Hoja de datos )
| Número de pieza | ADG706 | |
| Descripción | CMOS/ 2.5ohm Low-Voltage/ 8-/16-Channel Multiplexers | |
| Fabricantes | Analog Devices | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de ADG706 (archivo pdf) en la parte inferior de esta página. Total 11 Páginas | ||
|
No Preview Available !
a
CMOS, 2.5 ⍀ Low-Voltage,
8-/16-Channel Multiplexers
ADG706/ADG707
FEATURES
1.8 V to 5.5 V Single Supply
؎3 V Dual Supply
2.5 ⍀ On Resistance
0.5 ⍀ On-Resistance Flatness
100 pA Leakage Currents
40 ns Switching Times
Single 16-to-1 Multiplexer ADG706
Differential 8-to-1 Multiplexer ADG707
28-Lead TSSOP Package
Low-Power Consumption
TTL/CMOS-Compatible Inputs
APPLICATIONS
Data Acquisition Systems
Communication Systems
Relay Replacement
Audio and Video Switching
Battery-Powered Systems
FUNCTIONAL BLOCK DIAGRAMS
ADG706
S1
ADG707
S1A
S8A
DA
D
S1B
DB
S16 S8B
1-OF-16
DECODER
1-OF-8
DECODER
A0 A1 A2 A3 EN
A0 A1 A2 EN
GENERAL DESCRIPTION
The ADG706 and ADG707 are low-voltage, CMOS analog
multiplexers comprising 16 single channels and eight differential
channels respectively. The ADG706 switches one of 16 inputs
(S1–S16) to a common output, D, as determined by the 4-bit
binary address lines A0, A1, A2, and A3. The ADG707 switches
one of eight differential inputs to a common differential output as
determined by the 3-bit binary address lines A0, A1, and A2.
An EN input on both devices is used to enable or disable the
device. When disabled, all channels are switched OFF.
Low-power consumption and operating supply range of 1.8 V to
5.5 V make the ADG706 and ADG707 ideal for battery-powered,
portable instruments. All channels exhibit break-before-make
switching action preventing momentary shorting when switch-
ing channels. These devices are also designed to operate from a
dual supply of ± 3 V.
These multiplexers are designed on an enhanced submicron
process that provides low-power dissipation yet gives high-
switching speed, very low on resistance and leakage currents.
On resistance is in the region of a few ohms and is closely
matched between switches and very flat over the full signal
range. These parts can operate equally well as either multiplexers
or demultiplexers and have an input signal range which extends
to the supplies.
The ADG706 and ADG707 are available in small 28-lead TSSOP
packages.
PRODUCT HIGHLIGHTS
1. Single/Dual Supply Operation. The ADG706 and ADG707
are fully specified and guaranteed with 3 V and 5 V single
supply and ± 3 V dual supply rails.
2. Low On Resistance (2.5 Ω typical).
3. Low-Power Consumption (<0.01 µW).
4. Guaranteed Break-Before-Make Switching Action.
5. Small 28-Lead TSSOP Package.
REV. 0
Information furnished by Analog Devices is believed to be accurate and
reliable. However, no responsibility is assumed by Analog Devices for its
use, nor for any infringements of patents or other rights of third parties
which may result from its use. No license is granted by implication or
otherwise under any patent or patent rights of Analog Devices.
One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.
Tel: 781/329-4700 World Wide Web Site: http://www.analog.com
Fax: 781/326-8703
© Analog Devices, Inc., 2000
1 page  
ABSOLUTE MAXIMUM RATINGS1
(TA = 25°C unless otherwise noted)
VDD to VSS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 V
VDD to GND . . . . . . . . . . . . . . . . . . . . . . . . . . –0.3 V to +7 V
VSS to GND . . . . . . . . . . . . . . . . . . . . . . . . . . +0.3 V to –3.5 V
Analog Inputs2 . . . . . . . . . . . . . . VSS – 0.3 V to VDD + 0.3 V or
30 mA, Whichever Occurs First
Digital Inputs2 . . . . . . . . . . . . . . . . . –0.3 V to VDD + 0.3 V or
30 mA, Whichever Occurs First
Peak Current, S or D . . . . . . . . . . . . . . . . . . . . . . . . . . 100 mA
(Pulsed at 1 ms, 10% Duty Cycle max)
Continuous Current, S or D . . . . . . . . . . . . . . . . . . . . . 30 mA
Operating Temperature Range
Industrial (B Version) . . . . . . . . . . . . . . . . –40°C to +85°C
ADG706/ADG707
Storage Temperature Range . . . . . . . . . . . . –65°C to +150°C
Junction Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . 150°C
TSSOP Package
θJA Thermal Impedance . . . . . . . . . . . . . . . . . . . . 97.9°C/W
θJC Thermal Impedance . . . . . . . . . . . . . . . . . . . . . . 14°C/W
Lead Temperature, Soldering (10 seconds) . . . . . . . . . . 300°C
IR Reflow, Peak Temperature . . . . . . . . . . . . . . . . . . . . 220°C
NOTES
1Stresses above those listed under Absolute Maximum Ratings may cause perma-
nent damage to the device. This is a stress rating only, functional operation of the
device at these or any other conditions above those listed in the operational sections
of this specification is not implied. Exposure to absolute maximum rating condi-
tions for extended periods may affect device reliability. Only one absolute maximum
rating may be applied at any one time.
2Overvoltages at IN, S or D will be clamped by internal diodes. Current should be
limited to the maximum ratings given.
CAUTION
ESD (electrostatic discharge) sensitive device. Electrostatic charges as high as 4000 V readily
accumulate on the human body and test equipment and can discharge without detection. Although
the ADG706/ADG707 features proprietary ESD protection circuitry, permanent damage may
occur on devices subjected to high-energy electrostatic discharges. Therefore, proper ESD
precautions are recommended to avoid performance degradation or loss of functionality.
WARNING!
ESD SENSITIVE DEVICE
Model
ADG706BRU
ADG707BRU
Temperature Range
–40°C to +85°C
–40°C to +85°C
ORDERING GUIDE
Package Description
Thin Shrink Small Outline Package (TSSOP)
Thin Shrink Small Outline Package (TSSOP)
Package Option
RU-28
RU-28
PIN CONFIGURATIONS
28-Lead TSSOP
VDD 1
NC 2
NC 3
28 D
27 VSS
26 S8
S16 4
25 S7
S15 5
24 S6
S14 6
23 S5
ADG706
S13 7 TOP VIEW 22 S4
S12 8 (Not to Scale) 21 S3
S11 9
20 S2
S10 10
19 S1
S9 11
18 EN
GND 12
17 A0
NC 13
16 A1
A3 14
15 A2
NC = NO CONNECT
VDD 1
DB 2
NC 3
28 DA
27 VSS
26 S8A
S8B 4
25 S7A
S7B 5
24 S6A
S6B 6
S5B 7
23 S5A
ADG707
TOP VIEW 22 S4A
S4B 8 (Not to Scale) 21 S3A
S3B 9
20 S2A
S2B 10
19 S1A
S1B 11
18 EN
GND 12
17 A0
NC 13
16 A1
NC 14
15 A2
NC = NO CONNECT
REV. 0
–5–
5 Page 
OUTLINE DIMENSIONS
Dimensions shown in inches and (mm).
ADG706/ADG707
28-Lead TSSOP
(RU-28)
0.386 (9.80)
0.378 (9.60)
28
1
PIN 1
0.006 (0.15)
0.002 (0.05)
15
0.177 (4.50)
0.169 (4.30)
0.256 (6.50)
0.246 (6.25)
14
0.0433 (1.10)
MAX
SEATING
PLANE
0.0256 (0.65) 0.0118 (0.30)
BSC
0.0075 (0.19)
8؇
0.0079 (0.20) 0؇
0.0035 (0.090)
0.028 (0.70)
0.020 (0.50)
REV. 0
–11–
11 Page | ||
| Páginas | Total 11 Páginas | |
| PDF Descargar | [ Datasheet ADG706.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| ADG701 | CMOS Low Voltage 2ohm SPST Switches | Analog Devices |
| ADG701L | (ADG701L / ADG702L) CMOS Low Voltage 2 OHM SPST Switches | Analog Devices |
| ADG702 | CMOS Low Voltage 2ohm SPST Switches | Analog Devices |
| ADG702L | (ADG701L / ADG702L) CMOS Low Voltage 2 OHM SPST Switches | Analog Devices |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |