DataSheet.es    


PDF A540 Data sheet ( Hoja de datos )

Número de pieza A540
Descripción SILICON RECTIFIER
Fabricantes Powerex Power Semiconductors 
Logotipo Powerex Power Semiconductors Logotipo



Hay una vista previa y un enlace de descarga de A540 (archivo pdf) en la parte inferior de esta página.


Total 8 Páginas

No Preview Available ! A540 Hoja de datos, Descripción, Manual

5368
SMOKE DETECTOR
WITH INTERCONNECT AND TIMER
TIMER START 1
I/O 2
LOW-V SET 3
TIMER OUT 4
LED 5
+ SUPPLY 6 V DD
TIMING RES. 7
FEEDBACK 8
LOGIC
OSC. &
TIMING
HORN
DRIVER
16 GUARD 2
15 DETECT. IN
14 GUARD1
13
SENSITIVITY
SET
12 OSC. CAP.
11 HORN 2
10 HORN1
VSS 9 – SUPPLY
Dwg. PC-004
The A5368CA is a low-current, CMOS circuit providing all of the
required features for an ionization-type smoke detector. A networking
capability allows as many as 125 units to be interconnected so that if
any unit senses smoke, all units will sound an alarm. In addition,
special features are incorporated to facilitate alignment and test of the
finished smoke detector. This device is designed to comply with
Underwriters Laboratories Specification UL217.
The internal oscillator and timing circuitry keeps standby power to
a minimum by powering down the device for 1.66 seconds and sensing
smoke for only 10 ms. Every 24 on/off cycles, a check is made for low
battery condition. By substituting other types of sensors, or a switch
for the ionization detector, this very-low power device can be used in
numerous other battery-operated safety/security applications.
The A5368CA is supplied in a low-cost, 16-pin dual in-line plastic
package. It is rated for continuous operation over the temperature
range of 0°C to +50°C.
ABSOLUTE MAXIMUM RATINGS
(Voltages are referenced to VSS)
Supply Voltage Range,
VDD ................................ -0.5 V to +15 V
Reverse Battery (10.5 V) ....................... 20 s
Input Voltage Range,
VIN ........................ -0.3 V to VDD + 0.3 V
Input Current, IIN ............................... 10 mA
Operating Temperature Range,
TA ..................................... 0°C to +50°C
Storage Temperature Range,
TS ............................... -55°C to +125°C
CAUTION: CMOS devices have input static protection
but are susceptible to damage when exposed to
extremely high static electrical charges.
FEATURES
s Interconnect Up to 125 Detectors
s Piezoelectric Horn Driver
s Guard Outputs for Detector Input
s Pulse Testing for Low Battery
s Power-ON Reset
s Internal Reverse Battery Protection
s Internal Timer & Control for Reduced Sensitivity
s Built-In Hysteresis Reduces False Triggering
s Temporal Horn Pattern
Always order by complete part number: A5368CA .

1 page




A540 pdf
5368
SMOKE DETECTOR
WITH INTERCONNECT
AND TIMER
Sensitivity Adjust. The detector sensitiv-
ity to smoke is set internally by a voltage
divider connected between VDD and VSS. The
sensitivity can be externally adjusted to the
individual characteristics of the ionization
chamber by connecting a resistor between pin
13 and VDD, or between pin 13 and VSS.
Low Battery. The low battery threshold is
set internally by a voltage divider connected
between VDD and VSS. The threshold can be
increased by connecting a resistor between
pin 3 and VDD. The threshold can be de-
creased by connecting a resistor between pin
3 and VSS. The battery voltage level is
checked every 40 seconds during the 10 mA,
10 ms LED pulse. If an LED is not used, it
should be replaced with an equivalent resistor
(typically 500 to 1000 ) such that the
battery loading remains at 10 mA.
Timer. An internal timer is provided that
can be used in various configurations to allow
for a period of reduced smoke detector
sensitivity (“hush”). When a high-to-low
transition occurs at pin 1, the internal timer is
reset, the timer mode enabled, and the circuit
reset to a no alarm condition. The LED will
flash at a 10 second rate. If the level of
smoke is increased such that the reduced
sensitivity level is reached, the device will go
into the alarm condition. The timer, how-
ever, will continue to completion of the
nominal 10-1/4 minute period (368 clock
cycles). If the timer mode is not used, pin 1
should be tied low.
I/O. A connection is provided at pin 2 to
allow multiple smoke detectors to be
commoned. If any single unit detects smoke
(I/O is driven high), all connected units will
sound their associated horns after a nominal 3
second delay. The LED is suppressed when
an alarm is signaled from an interconnected
TYPICAL APPLICATION
9V
TIMER
MODE
200 k
TO
OTHER
UNITS
200
1
2
NOTE
3
330
3
4
5
LOGIC
OSC. &
TIMING
8.2 M
6 V DD
7
HORN
DRIVER
1 µF
8
16
15
14
13
12
11
10
V SS 9
0.1 µF
NOTE 2
PUSH
TO
TEST
NOTE
1
0.001 µF
Dwg. EC-005A
NOTE 1: Use an external resistor to adjust sensitivity for a particular smoke
chamber.
NOTE 2: Select resistor to reduce sensitivity during timer mode.
NOTE 3: Abatrteesriystvoor lttoaggerothurnedshoorlVd.DD may be added to this pin to modify low
unit. An internal NMOS device acts as a charge dump to aid in appli-
cations involving a large (distributed) capacitance on pin 2. The
charge dump is activated only on the removal of a local alarm.
Testing. On power up, all internal counters are reset. Internal test
circuitry allows for low battery check by holding pins 8 and 12 low
during power up, then reducing VDD and monitoring HORN1 (pin 10).
All functional tests can be accelerated by driving pin 12 with a 2 kHz
square wave. The 10 ms strobe period must be maintained for proper
operation of the comparator circuitry.

5 Page










PáginasTotal 8 Páginas
PDF Descargar[ Datasheet A540.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
A545 TO 500 MHz CASCADABLE AMPLIFIERTyco Electronics
Tyco Electronics
A540SILICON RECTIFIERPowerex Power Semiconductors
Powerex Power Semiconductors
A540LSILICON RECTIFIERPowerex Power Semiconductors
Powerex Power Semiconductors
A540LASILICON RECTIFIERPowerex Power Semiconductors
Powerex Power Semiconductors

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar