DataSheet.es    


PDF QLX4600-S30 Data sheet ( Hoja de datos )

Número de pieza QLX4600-S30
Descripción Quad Lane Extender
Fabricantes Intersil　
Logotipo Intersil Logotipo



Hay una vista previa y un enlace de descarga de QLX4600-S30 (archivo pdf) en la parte inferior de esta página.


Total 23 Páginas

No Preview Available ! QLX4600-S30 Hoja de datos, Descripción, Manual

DATASHEET
Quad Lane Extender
QLX4600-S30
The QLX4600-S30 is a settable quad receive-side equalizer
with extended functionality for advanced protocols operating
with line rates up to 6.25Gb/s such as DisplayPort v1.2
(HBR1/2), InfiniBand (SDR and DDR), PCI Express and
10GBase-CX4. The QLX4600-S30 compensates for the
frequency dependent attenuation of copper twin-axial cables,
extending the signal reach up to 30m on a 24AWG cable.
The small form factor, highly-integrated quad design is ideal
for high-density data transmission applications including
active copper cable assemblies. The four equalizing filters
within the QLX4600-S30 can each be set to one of 32
compensation levels, providing optimal signal fidelity for a
given media and length. The compensation level for each filter
can be set by either (a) three external control pins or (b) a
serial bus interface. When the external control pins are used,
18 of the 32 boost levels are available for each channel. If the
serial bus is used, all 32 compensation levels are available.
Operating on a single 1.2V power supply, the QLX4600-S30
enables per channel throughputs of up to 6.25Gb/s while
supporting lower data rates including 5, 4.25, 3.125 and
2.5Gb/s. The QLX4600-S30 uses Current Mode Logic (CML)
inputs/outputs and is packaged in a 4mmx7mm 46 Ld TQFN.
Individual channel power-down support is included for PCI
Express applications.
Features
• Supports data rates up to 6.25Gb/s
• Low power (78mW per channel)
• Low latency (<500ps)
• Four equalizers in a 4mmx7mm TQFN package for straight
route-through architecture and simplified routing
• Each equalizer boost is independently pin selectable and
programmable
• Beacon signal support and line silence preservation
• Channel power-down for each equalizer
• 1.2V supply voltage
Applications
• DisplayPort v1.2 active copper cable modules
• InfiniBand (SDR and DDR)
• 10GBase-CX4
• PCI Express Gen 1 and 2
• XAUI and RXAUI, SAS (1.0 and 2.0)
• High-speed active cable assemblies
• High-speed Printed Circuit Board (PCB) traces
Benefits
• Thinner gauge cable
• Extends cable reach greater than 3x
• Improved BER
June 23, 2016
FN6979.2
FIGURE 1. TYPICAL APPLICATION CIRCUIT
1 CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-468-3774 | Copyright Intersil Americas LLC 2009, 2016. All Rights Reserved
Intersil (and design) and Q:ACTIVE are trademarks owned by Intersil Corporation or one of its subsidiaries.
All other trademarks mentioned are the property of their respective owners.

1 page




QLX4600-S30 pdf
QLX4600-S30
Absolute Maximum Ratings
Supply Voltage (VDD to GND). . . . . . . . . . . . . . . . . . . . . . . . . . . -0.3V to 1.3V
Voltage at All Input Pins. . . . . . . . . . . . . . . . . . . . . . . . . . -0.3V to VDD + 0.3V
ESD Rating at All Pins . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2kV (HBM)
Thermal Information
Thermal Resistance (Typical)
JA (°C/W) JC (°C/W)
46 Ld TQFN Package (Note 4) . . . . . . . . . .
32
2.3
Operating Ambient Temperature Range . . . . . . . . . . . . . . . . .0°C to +70°C
Storage Ambient Temperature Range. . . . . . . . . . . . . . . . -55°C to +150°C
Maximum Junction Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . . +125°C
Pb-Free Reflow Profile . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .see TB493
CAUTION: Do not operate at or near the maximum ratings listed for extended periods of time. Exposure to such conditions may adversely impact product
reliability and result in failures not covered by warranty.
NOTES:
4. JA is measured with the component mounted on a high effective thermal conductivity test board in free air. See Tech Brief TB379 for details.
5. For JC, the “case temp” location is the center of the exposed metal pad on the package underside.
Operating Conditions
PARAMETER
Supply Voltage
Operating Ambient Temperature
Bit Rate
SYMBOL
TEST CONDITIONS
VDD
TA
NRZ data applied to any channel
MIN
(Note 7)
1.1
0
1.5
MAX
TYP (Note 7) UNIT
1.2 1.3
V
25 70 °C
6.25
Gb/s
Control Pin Characteristics Typical values are at VDD = 1.2V, TA = +25°C, and VIN = 800mVP-P, unless otherwise noted. VDD = 1.1V to
1.3V, TA = 0°C to +70°C.
PARAMETER
SYMBOL
TEST CONDITIONS
MIN
(Note 7)
MAX
TYP (Note 7)
UNIT NOTES
Input ‘LOW’ Logic Level
Input ‘HIGH’ Logic Level
Output ‘LOW’ Logic Level
Output ‘HIGH’ Logic Level
‘LOW’ Resistance State
VIL DI, CLK, ENB
VIH DI, CLK, ENB
VOL IS[k], DO, MODE
VOH IS[k], DO, MODE
CP[k][A,B,C]
0
750
0
1000
0
0
0
350 mV
VDD mV
250 mV
VDD mV
1 kΩ
6
‘MID’ Resistance State
CP[k][B,C]
22.5 25 27.5 kΩ
6
‘HIGH’ Resistance State
CP[k][A,B,C]
500 kΩ 6
Input Current
Current draw on digital pin, i.e., CP[k][A,B,C],
DI, CLK, ENB or MODE
30 100 µA
NOTE:
6. If four CP pins are tied together, the resistance values in this table should be divided by four.
Submit Document Feedback
5
FN6979.2
June 23, 2016

5 Page





QLX4600-S30 arduino
QLX4600-S30
Typical Performance Characteristics (Continued)
0
Channel 1
-5 Channel 2
Channel 3
-10 Channel 4
-15
-20
-25
-30
0 0.5 1 1.5 2 2.5 3 3.5
Frequency (GHz)
FIGURE 17. INPUT COMMON-MODE RETURN LOSS
4
0
Channel 1
-5 Channel 2
Channel 3
-10 Channel 4
-15
-20
-25
-30
0 0.5 1 1.5 2 2.5 3 3.5
Frequency (GHz)
FIGURE 18. OUTPUT COMMON-MODE RETURN LOSS
4
0
-5
-10
-15
-20
-25
Channel 1
Channel 2
-30 Channel 3
Channel 4
-35
0 0.5 1 1.5 2 2.5 3 3.5 4
Frequency (GHz)
FIGURE 19. INPUT DIFFERENTIAL RETURN LOSS
0
Channel 1
-5 Channel 2
Channel 3
-10 Channel 4
-15
-20
-25
-30
-35
0 0.5 1 1.5 2 2.5 3 3.5
Frequency (GHz)
FIGURE 20. OUTPUT DIFFERENTIAL RETURN LOSS
4
FIGURE 21. DIFFERENTIAL CROSSTALK BETWEEN ADJACENT INPUT
CHANNEL
NOTE:
18. Differential transmit amplitude = 1200mVP-P.
Submit Document Feedback 11
FIGURE 22. DIFFERENTIAL CROSSTALK BETWEEN ADJACENT INPUT
CHANNELS
FN6979.2
June 23, 2016

11 Page







PáginasTotal 23 Páginas
PDF Descargar[ Datasheet QLX4600-S30.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
QLX4600-S30Quad Lane ExtenderIntersil
Intersil

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

 Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

 Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar