DataSheetWiki


S6E2C4AH0A fiches techniques PDF

Cypress Semiconductor - Microcontroller

Numéro de référence S6E2C4AH0A
Description Microcontroller
Fabricant Cypress Semiconductor 
Logo Cypress Semiconductor 





1 Page

No Preview Available !





S6E2C4AH0A fiche technique
S6E2C4 Series
32-bit ARM® Cortex®-M4F
FM4 Microcontroller
Devices in the S6E2C4 Series are highly integrated 32-bit microcontrollers with high performance and competitive cost. This
series is based on the ARM Cortex-M4F processor with on-chip flash memory and SRAM. The series has peripherals such as
motor control timers, A/D converters, and communications interfaces (USB, CAN, UART, CSIO (SPI), I2C, LIN). The products that
are described in this data sheet are placed into TYPE3-M4 product categories "FM4 Family Peripheral Manual Main Part
(002-04856)."
Features
32-bit ARM Cortex-M4F Core
Processor version: r0p1
Up to 200 MHz frequency operation
FPU built-in
Support DSP instructions
Memory protection unit (MPU): improves the reliability of an
embedded system
Integrated nested vectored interrupt controller (NVIC): 1 NMI
(non-maskable interrupt) and 128 peripheral interrupts and
16 priority levels
24-bit system timer (Sys Tick): system timer for OS task
management
External Bus Interface
Supports SRAM, NOR, NAND flash and SDRAM device
Up to 9 chip selects CS0 to CS8 (CS8 is only for SDRAM)
8-/16-/32-bit data width
Up to 25-bit address bus
Supports address/data multiplexing
Supports external RDY function
Supports scramble function
Possible to set the validity/invalidity of the scramble
function for the external areas 0x6000_0000 to
0xDFFF_FFFF in 4 Mbytes units.
Possible to set two kinds of the scramble key
Note: It is necessary to use the Cypress provided software
library to use the scramble function.
On-chip Memories
Flash memory
This series is based on two independent on-chip flash
memories.
Up to 2048 Kbytes
Built-in flash accelerator system with 16 Kbytes trace buffer
memory
Read access to flash memory that can be achieved without
wait-cycle up to an operating frequency of 72 MHz. Even at
the operating frequency more than 72 MHz, an equivalent
single cycle access to flash memory can be obtained by
the flash accelerator system.
Security function for code protection
SRAM
This is composed of three independent SRAMs (SRAM0,
SRAM1 and SRAM2). SRAM0 is connected to the I-code bus
or D-code bus of Cortex-M4F core. SRAM1 and SRAM2 are
connected to system bus of Cortex-M4F core.
SRAM0: up to 192 Kbytes
SRAM1: 32 Kbytes
SRAM2: 32 Kbytes
CAN Interface (Max two Channels)
Compatible with CAN specification 2.0A/B
Maximum transfer rate: 1 Mbps
Built-in 32-message buffer
CAN-FD Interface (One Channel)
Compatible with CAN Specification 2.0A/B
Maximum transfer rate: 5 Mbps
Message buffer for receiver: up to 192 messages
Message buffer for transmitter: up to 32 messages
CAN with flexible data rate (non-ISO CAN-FD)
Notes:
CAN FD cannot communicate between non-ISO CAN FD
and ISO CAN FD, because non-ISO CAN FD and ISO
CAN FD are different frame format.
About the problem of "non-ISO CAN FD", see the White
Paper from CiA(CAN in Automation).
http://www.can-newsletter.org/engineering/standardization/
141222_can-fd-and-crc-issued_white-paper_bosch
Cypress Semiconductor Corporation
Document Number: 002-04986 Rev.*A
• 198 Champion Court • San Jose, CA 95134-1709 • 408-943-2600
Revised February 5, 2016

PagesPages 30
Télécharger [ S6E2C4AH0A ]


Fiche technique recommandé

No Description détaillée Fabricant
S6E2C4AH0A Microcontroller Cypress Semiconductor
Cypress Semiconductor

US18650VTC5A

Lithium-Ion Battery

Sony
Sony
TSPC106

PCI Bus Bridge Memory Controller

ATMEL
ATMEL
TP9380

NPN SILICON RF POWER TRANSISTOR

Advanced Semiconductor
Advanced Semiconductor


www.DataSheetWiki.com    |   2020   |   Contactez-nous  |   Recherche