DataSheetWiki


HV860 fiches techniques PDF

Supertex - Dimmable EL Lamp Driver

Numéro de référence HV860
Description Dimmable EL Lamp Driver
Fabricant Supertex 
Logo Supertex 





1 Page

No Preview Available !





HV860 fiche technique
HV860
Low Noise, Dimmable
EL Lamp Driver
Features
Adjustable output regulation for dimming
220VPP output voltage for higher brightness
Single cell lithium ion compatible
150nA shutdown current
Separately adjustable lamp and converter frequencies
3x3mm 12-Lead QFN package
Split supply capability
Applications
Mobile cellular phone keypads
PDAs
Handheld wireless communication products
Global Positioning Systems (GPS)
General Description
The Supertex HV860 is a high voltage driver designed for
driving Electroluminescent, (EL), lamps of up to 5 square
inches. The input supply voltage range is from 2.5 to 4.5V.
The device uses a single inductor and a minimum number of
passive components. Using the internal reference voltage,
the regulated output voltage is at a nominal voltage of 110V.
The EL lamp will therefore see ±110V. An enable pin, (EN),
is available to turn the device on and off via a logic signal.
The HV860 has two internal oscillators, a switching
MOSFET, and a high voltage EL lamp driver H-bridge. The
frequency for the switching MOSFET is set by an external
resistor connected between the RSW-Osc pin and the
supply pin VDD. The EL lamp driver frequency is set by
an external resistor connected between REL-Osc pin and
VDD pin. An external inductor is connected between the LX
and VDD pins or VIN for split supply applications. A 3.0nF
capacitor is connected between CS and ground. The EL
lamp is connected between VA and VB.
The switching MOSFET charges the external inductor and
discharges it into the capacitor at CS. The voltage at CS will
start to increase. Once the voltage at CS reaches a nominal
value of 110V, the switching MOSFET is turned OFF to
conserve power. The outputs VA and VB are configured as
an H bridge and are switching in opposite states to achieve
±110V across the EL lamp.
EL lamp dimming can be accomplished by changing the
input voltage to the VREG pin. The VREG pin allows an
external voltage source to control the VCS amplitude. The
VCS voltage is approximately 87 times the voltage seen on
VREG.
Typical Application Circuit
VIN
CIN
RREG
LX
D
VDD
CDD
1.5V = On
0V = Off
RSW
REL
2 35
VREG VREF LX
10 VDD
CS 7
12 RSW-Osc
1 REL-Osc
VA 9
11 EN
GND
VB 8
4 HV860
CS
EL
Lamp
1235 Bordeaux Drive, Sunnyvale, CA 94089 Tel: 408-222-8888 www.supertex.com

PagesPages 8
Télécharger [ HV860 ]


Fiche technique recommandé

No Description détaillée Fabricant
HV860 Dimmable EL Lamp Driver Supertex
Supertex
HV861 Dual EL Lamp Driver Supertex
Supertex
HV862 Dual EL Lamp Driver Supertex
Supertex

US18650VTC5A

Lithium-Ion Battery

Sony
Sony
TSPC106

PCI Bus Bridge Memory Controller

ATMEL
ATMEL
TP9380

NPN SILICON RF POWER TRANSISTOR

Advanced Semiconductor
Advanced Semiconductor


www.DataSheetWiki.com    |   2020   |   Contactez-nous  |   Recherche