|
|
PDF WM8993 Data sheet ( Hoja de datos )
| Número de pieza | WM8993 | |
| Descripción | Audio Hub CODEC | |
| Fabricantes | Wolfson Microelectronics | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de WM8993 (archivo pdf) en la parte inferior de esta página. Total 30 Páginas | ||
|
No Preview Available !
w
WM8993
Audio Hub CODEC for Multimedia Phones
DESCRIPTION
FEATURES
The WM8993 is a highly integrated ultra-low power hi-fi CODEC
designed for portable devices such as multimedia phones.
A stereo 1W/channel speaker driver can operate in class D or
AB mode. Low leakage and high PSRR across the audio band
enable direct battery connection for the speaker supply.
Class W headphone drivers provide a dramatic reduction in
playback power and are ground-referenced. Active ground loop
noise rejection and DC offset correction help prevent pop noise
and ground noise from degrading headphone output quality.
Powerful mixing capability allows the device to support a huge
range of architectures and use cases. A highly flexible input
configuration supports multiple microphone or line inputs (mono
or stereo, single-ended or differential).
Fully differential internal architecture and on-chip RF noise
filters ensure a very high degree of noise immunity.
ReTuneTM Mobile parametric EQ with fully programmable
coefficients is integrated for optimization of speaker
characteristics. Programmable dynamic range control is also
available for maximizing loudness, protecting speakers from
clipping and preventing premature shutdown due to battery
droop.
The WM8993 is supplied in very small and thin 48-ball W-CSP
package, ideal for portable systems.
• 100dB SNR during DAC playback (‘A’ weighted)
• Low power, low noise MIC interface
• Class D or AB stereo speaker driver
- Stereo1W into 8Ω BTL speaker at <1% THD
- Mono 2W into 4Ω BTL speaker
• ReTuneTM Mobile parametric equalizer
• Dynamic range controller
• Low power Class W headphone drivers
- Integrated charge pump and DC offset correction
- 5mW total power for DAC playback to headphones
• Digital audio interface
- All standard data formats and 2-channel TDM supported
- All standard sample rates from 8kHz to 48kHz
• Low power FLL
- Provides all necessary internal clocks
- 32kHz to 27MHz input frequency
- Free-running mode for class D and charge pump
• 4 highly flexible line outputs (single-ended or differential )
• Dedicated earpiece driver
• “Direct voice” and “Direct DAC” paths to outputs
- Low noise paths bypass all internal mixers
- Low power consumption
• Active noise reduction
- DC offset correction removes pops and clicks
- Ground loop noise cancellation
• 48-ball W-CSP package (3.64x3.54x0.7mm, 0.5mm pitch)
APPLICATIONS
• Multimedia phones
WOLFSON MICROELECTRONICS plc
To receive regular email updates, sign up at http://www.wolfsonmicro.com/enews
Production Data, November 2010, Rev 4.0
Copyright ©2010 Wolfson Microelectronics plc
1 page  
Production Data
BLOCK DIAGRAM
w
WM8993
CPVDD
CPGND
LINEOUTFB
HPOUT1FB
SPKMONO
SDAT
SCLK
GPIO1
ADCDAT
DACDAT
LRCLK
BCLK
GPIO1
MCLK
AVDD1
VMIDC
AGND
PD, November 2010, Rev 4.0
5
5 Page 
Production Data
WM8993
ELECTRICAL CHARACTERISTICS
Test Conditions
DCVDD = 1.2V, AVDD2 = DBVDD = CPVDD = 1.8V, AVDD1 = 3.0V, SPKVDD = 5V, DGND=AGND=CPGND=SPKGND=0V,
TA = +25oC, 1kHz sinusoidal signal, fs = 48kHz, PGA gain = 0dB, 24-bit audio data unless otherwise stated.
PARAMETER
TEST CONDITIONS
MIN TYP MAX
Analogue Input Pin Maximum Signal Levels (IN1LN, IN1LP, IN2LN, IN2LP, IN1RN, IN1RP, IN2RN, IN2RP)
A1 Maximum Full-Scale PGA Single-ended PGA input
Input Signal Level
1.0
0
UNIT
Vrms
dBV
Note 1,2 and 3
Differential PGA input
1.0 Vrms
0 dBV
A2 Maximum Full-Scale Line Single-ended Line input
Input Signal Level
to mixers
Note 1, 2 and 3
1.0 Vrms
0 dBV
Differential mono line
input on VRXP/VRXN to
RXVOICE or Direct Voice
paths to speaker outputs
or earpiece output
1.0 Vrms
0 dBV
Notes:
1. This changes in proportion to AVDD1 (AVDD1/3.0)
2. When mixing line inputs, input PGA outputs and DAC outputs the total signal must not exceed 1Vrms (0dBV).
3. A 1.0Vrms differential signal equates to 0.5Vrms/-6dBV per input.
w
PD, November 2010, Rev 4.0
11
11 Page | ||
| Páginas | Total 30 Páginas | |
| PDF Descargar | [ Datasheet WM8993.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| WM8991 | Mobile Multimedia CODEC | Wolfson Microelectronics |
| WM8993 | Audio Hub CODEC | Wolfson Microelectronics |
| WM8994 | Multi-Channel Audio Hub CODEC | Wolfson Microelectronics |
| WM8995L | Tereo DAC | Wolfson Microelectronics |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |